![]() Please spread the word, a few easy measurements would be GREATLY appreciated! Is there someone out there with the Rancho 4" lift that I could get some measurements from? I've been going off of pictures of the Rancho knuckles and comparing to stock knuckles to get a half-assed idea of where I should be, but actual measurements would be awesome to help clarify. It's not even that bad right now, but I'm picky. Sooooo, I'm ordering another set of knuckles, re-drilling them, and tapering them bottom-up. I should have tapered the tie rod mounts from the bottom-up. My tie rod angle is too flat in comparison to my a-arms. ![]() It still has a bit of bump steer.but after doing some more research on what causes bump steer, and going over the H3 Rancho 4" lift installation instructions (the pictures offered alot of insight), I think I know why its happening. ![]() Little update: I changed out my leaf spring bushings and frame bushings (they were absolutely shot, causing alot of ass end sway haha), added air bags in the rear, and installed the front sway bar (cut the stock end links in half and welded in some 1/2" pipe to extend them to 8 1/2").
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |